Tadano GT-550E-2, Руководство по эксплуатации и обслуживанию

Страница: 51 / 100

At the End of Operation
1.
Stow the single top or jib.
(“Single Top” ………………………………………… P. 95)
(“Jib” ………………………………………………… P. 100)
2.
Stow the main hook block and stow the boom on
the boom rest.
(“Taking Out and Stowing the Main Hook Block”
…………………………………………………… P. 88)
3.
Make sure that the controls in the crane operator’s
cab are in the following positions:
(1) Hoist, boom telescoping, boom elevating, and swing
levers
……………………………………………
Neutral
(2) Swing brake switch
………………………………
“ON”
4.
Return the lever stand to the stowage position.
5.
Shut off the air conditioner, oil cooler and all other
equipment.
(“Equipment Inside the Cab” ……………………… P. 125)
6.
Close all the crane operator’s cab windows.
7.
Remove the key from the starter switch in the crane
operator’s cab.
(“Starting and Stopping the Engine”
…………………
P.54)
8.
Get out of the crane operator’s cab and lock the
door.
(“Crane Operator’s Cab” …………………………… P.66)
9.
Retract the front jack.
(“Outriggers”
…………………………………………
P. 58)
10.
Retract the outriggers completely.
(“Outriggers” ………………………………………… P. 58)
11.
Disengage the PTO.
(“Operating the PTO and Warming Up the Machine”
…………………………………………………… P. 57)
12.
Stop the engine by using the starter switch in the
carrier driver’s cab.
(“Starting and Stopping the Engine”
………………
P. 54)
13.
Perform the post-operational checks for the same
points as for the pre-operational checks. If anything ab-
normal is found, have it repaired before operating the
crane again.
T038280E
15
Crane Operation Procedure—Summary Crane Operation Procedure—Summary
T23069E
Lever stand
Unlock lever
Stowage position
(for traveling)
Position for crane operation