Tadano GT-550E-2, Руководство по эксплуатации и обслуживанию

Страница: 85 / 100

T038300E
49
AML (Overload Prevention Device) AML (Overload Prevention Device)
Messages Meanings Causes Solutions
[Warning:0027] Lower boom angle Boom is lowered below the lower Raise the boom.
restricted boom angle restriction. Cancel lower boom angle
restriction.
[Warning:0028] Lifting height restricted Lifting height is beyond lifting Lower the boom.
height restriction. Retract the boom.
Cancel lifting height restriction.
[Warning:0029] Load radius restricted Load radius is beyond Raise the boom.
load radius restriction. Retract the boom.
Cancel load radius restriction.
[Warning:0042] Right swing angle restricted Boom is swung beyond the swing Swing back the boom.
[Warning:0043] Left swing angle restricted restriction.
Cancel the swing restriction function.
[Warning:0046] Unexpected outrigger Outrigger is retracted. Register operational status again.
retraction
[Warning:0057] R.F. outrigger state change Outrigger state change as to Re-extend outrigger.
[Warning:0058] R.R. outrigger state change decrease extension. Register operational status again.
[Warning:0059] L.F. outrigger state change Crane performance shifted to that
[Warning:0060] L.R. outrigger state change with smaller outrigger extension.
[Error:0006] Pins inserted in jib Jib connecting pin and jib set pin Set the pins on the jib to normal
inserted. conditions.
[Warning:0011] Connecting pin uninserted Jib connecting pin is not inserted.
[Warning:0077] Front jack moved Front jack is operated. Extend the front jack again and re-
register the front jack status.
[Warning:0081] Elevation slowed down Elevation slow stop function is Stop operation.
activated and the elevation
Elevate the boom to the opposite direction.
speed is reduced because the Cancel the boom angle restriction.
limit angle is approaching due to Move the boom toward non-critical
boom elevation. side.
[Warning:0082] Swinging slowed down Swing slow stop function is Stop operation.
activated and the swing speed is Swing back the boom.
reduced because the limit angle is Retract the boom.
approaching due to boom swing. Raise the boom.
Cancel the swing restriction func-
tion.
[Warning:0085] Stroke end of elevation Boom elevation is automatically Stop operation.
cylinder stopped as it reaches the stroke Operate in the opposite direction.
end.
[Warning:0088] Moment exceeding limit During lifting a load on the boom Hoist down the winch.
for boom with jib mounted with the jib moment ratio beyond Raise the boom.
85%. Retract the boom.
Others ─
AML main body or detector Check or repair required. Contact
defective nearest TADANO distributor or
dealer. For crane stowing, see
“
Disposition of System Troubles
”
.