PROGRAMMING PROCEDURE
MOTOR
WORKING TIME
PROGRAMMING
P1
is a semi-automatic procedure to acquire the working time parameters. The working
time parameters are
A1
,
A2
and
F0
. In other words, after this procedure the standard
working time, the slowdown working time of the motor and the pause time are acquired by
the control board. Before beginning this procedure, check that: all safety devices are
connected, the control board is in stand by state and the sense of rotation of the motor is
correct. To begin this procedure hold down or keep pressing button A or B until the control
board display shows
P1
. After a few seconds the control board display shows
__
.
After pressing a start input, the procedure will start. This procedure is subdivided into 3 steps.
They are called:
A1
,
A2
and
F0
. In each step the linked parameter is programmed. During
the whole programming procedure the obstacle detection sensor is disabled.
P1
→
__
The control board is ready to start the motor working time programming.
To go to
A1
press any start input.
A1
The standard working time of the motor(
A1
) is being programmed.
The gate is opening.
To go to
A2
press any start input.
A2
The slowdown working time of the motor (
A2
) is being programmed.
The gate is slowing down.
To go to
F0
press any start input.
F0
The pause time is being programmed (
F0
).
The gate is stopped. The flashing lamp is on. After 1.5 seconds the control
board display shows the counting time. To finish the programming press
any start input and wait until the gate is completely closed.
P1
AUTOMATIC
PROGRAMMING
P3
P3
is an automatic procedure to acquire the working time parameters. The working time
parameters are
A1
,
A2
and
F0
. Before beginning this procedure, check that: all safety
devices are connected, the control board is in stand by state and the sense of rotation of each
motor is correct. To begin this procedure hold down or keep pressing button A or B until the
control board display shows
P3
. After a few seconds the control board display shows
__
.
After pressing a start input, the procedure will be started.
When the one leaf swing gate or the sliding gate reaches the physical limit switch (stop limit),
the control unit stops the motors and executes a 10 seconds pause, after which the gate will
start closing having programmed all working times. If the control unit cannot detect the stop
limit, the auto-programming cannot be performed on that installation. In this case: Press a
Start input to put back manually the control unit in the pause state, wait until the gate is
completely closed, after that program manually the parameters of the control unit or execute
the sequential procedure
P1
.
www.tecnoautomazione.com
Pag. 13 / 17