REMOTE
SINGLE ERASE
Keep pressing A or B button until the display shows
r0
. After a few seconds the control
board starts scanning for stored codes. Each code showed is a remote key
ID.
To erase hold
down button C. The display blinks showing remote key
ID
. When the display is off the
remote key
ID
has been erased.
r0
STORING A REMOTE
A remote key can be stored as:
START
r1
,
STOP
r2
,
PEDESTRIAN
r3
or
FAST CLOSURE
r4
.
Hold down or keep pressing A or B button on the control board until the display shows the
chosen function
r1
,
r2
,
r3
or
r4
. After about one second, the display shows
=_
. Hold
down an unsaved remote key. The display shows
._
. To save push down the button C on
the control board. After saving, the display shows the remote key identification number.
The
control board holds up to 99 remote codes
. If the memory is full, the display shows
FF
when trying to save the remote key.
•
r1
START
The
start function
begins a
Standard Working Cycle
: The
motor
works for a total
time of
A1
plus
A2
seconds during the opening and the closing
.
•
r2
STOP
The
stop function
stops the gate.
•
r3
PEDESTRIAN
The
pedestrian
function
begins a
Pedestrian Working Cycle
: The
motor
works for a
total time of
F1
seconds during the opening and closing. The slowdown phase is
skipped during the opening and executed during the closing. The slowdown time is
automatically managed by the control board during a pedestrian working cycle.
•
r4
FAST CLOSURE
During the opening
: once the external photocells have been activated, the gate starts
closing after 5 seconds.
During the pause time
F0
: once the external photocells have been activated, the
gate starts closing.
For safety reasons it is advisable to link this function to a remote key only when two pairs of
external photocells are installed as shown in
TYPICAL INSTALLATION .
r1
START
r2
STOP
r3
PEDESTRIAN
r4
FAST
CLOSURE
ERASING ALL
Keep pressing A or B button until the display shows
r5
. After a few seconds the control
board shows
no
. To erase all stored codes, hold down button C until the display stops
flashing
SI
(YES).
r5
www.tecnoautomazione.co
m
Pag. 11 / 17