Syntec 70SB, Руководство пользователя

Страница: 40 / 46

自動化產品
/Automation Products
–
70SB Laser Marking Machine Assembly Manual(Discontinued)
Troubleshooting Q&A – 40
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
11 Troubleshooting Q&A
11.1 Galvanometer
Problem Fi
gu
re Possible
cause Elimination methods
Start marking. No
action on the
galvanometer - 1. Not
properly
powered up
2. Wiring
problem
3. Parameter
error
4.Controller
hardware
problem
1. Check whether
the +-15V power supply
has normal output.
2. Wiring problem
1. Check whether
the wire is properly
connected
2. Confirm whether
the standard 15pin wire
is used, and test if the
wire is abnormal using
the wire of the same
standard
3. Use an avometer
and other equipment to
confirm whether the
wire pins are properly
connected
3. Parameter error
1. Check whether
the Kp coefficient of the
galvanometer is correct
(the controller has no
such function)
2. Confirm R17008
(operation mode) =2
(transferring while
marking)
4. Controller
hardware problem
1. Confirm whether
R17111~R17113 output
the control signal in
Register, and if so, use
the electricity meter to
confirm whether the
corresponding pin
output the normal
voltage value