Environment and safety procedures
Programming instructions of the
SYCLOPE INDIG’O
®
II.
Environment and safety procedures
Please:
Read this manual carefully before unpacking, installing or commissioning this equipment
Take into account all the hazards and recommended precautionary measures
Failure to respect these procedures can result in serious injury to users or damage the device.
1)
Use of the equipment
The
SYCLOPE INDIG’O
®
system has been designed to measure and control Chlorine, Bromine, pH,
Redox potential, Ozone, etc… by means of sensors and controls of suitable actuators in the context of
the possible uses described in this manual.
All other uses are considered to be non-conforming and must therefore be forbidden. SYCLOPE
Electronique S.A.S. will not be responsible in any case for any damages that result from such
uses.
Any use of sensors or interfaces not-in conformity to the features defined in this handbook
must also be proscribed.
2)
User obligations
The user undertakes not to allow its employees to work with the
SYCLOPE INDIG’O
®
equipment
described in this manual unless they:
Are aware of the fundamental instructions relating to work safety and prevention of accidents
Are trained in the use of the device and its environment
Have read and understood these instructions, warnings and manipulation rules
3)
Risk prevention
The installation and connection of the
SYCLOPE INDIG’O
®
equipment should only be
performed by personnel specialized and qualified for this task.
The installation must comply with current safety standards and instructions!
Before switching on the controller or manipulating the relay outputs, remember always to cut
off the primary power supply!
Never open the controller when it is powered on!
Maintenance operations and repairs should only be performed by trained, specialized
personnel!
Take care when choosing the location for installing the equipment according to the
environment!
The
SYCLOPE INDIG’O
®
electronic box should not be installed in a hazardous environment
and should be protected against splashing with water or chemical products. It should be
installed in a dry, well-ventilated location, isolated from corrosive vapours.