22
Alerting „Emergency call“
5.2 Illumination of the emergency call key of the phone
Type of illumination
Explanation
Unilluminated
Alert function is switched off
Lights in a constantly weak red
Alert function is switched on
Lights in a consistently strong red
Emergency call numbers are dialled
Flashes in a consistently strong red
Pause between two cycles
5.3 Programming and testing the emergency call function
First, the basic settings in chapter 4 „Alert function“ are to be programmed:
Run. No. Basic settings „Alert function“
Page
1
4.5.1 Switching on the alert function (factory pre-set:
switched on)
17
2
4.5.2 Determining and storing alert call numbers
18
3
4.5.3 Setting alert parameters
19
After this, program and test the emergency call:
Run. No. Setting and testing the emergency call function
Page
4
5.3.1 Assigning alert call number(s)
22
5
5.3.2 Setting the emergency call announcement
24
6
5.3.3 Testing the emergency call
26
5.3.1 Assigning alert call number(s) to the emergency call key
The alert call numbers can be assigned to the call trigger „emergency call
key“,
Establishing the settings:
ATTENTION
In the following procedure it is not the call number itself
which is allocated but instead the memory location in which
the number is stored (see table on the page 18).
Example: If you want to assign the first 3 numbers, so enter
