Swisson XND-4D, Руководство пользователя

Страница: 17 / 34

17
The Art-Net sub-uni is computed from the sub-net and the universe of a port as 16 x sub-net + universe. Some
controllers address the Art-Net universe as a single number in the range of 0 to 255. Sub-uni corresponds to that
number.
If an input port is configured for Art-Net v3, data is transmitted to the directed broadcast IP address (e.g.
2.255.255.255).
sACN
Ports that are running in sACN mode display the sACN universe number and status indicators.
The sACN universe number may be in the range of 1 – 63999. While the universe (large
number at the bottom) is being edited but has not yet been stored, a slowly blinking cursor
is shown below the currently editable digit. Use the encoder to increase or decrease that
digit. Push the port button corresponding to the port that is being edited to change the digit
that is currently editable.
If an input port is configured for sACN, data is transmitted to the sACN multicast IP address of the respective
universe (e.g. 239.255.0.1 for universe 1) or to a previously configured unicast IP address.
Mode
Under Mode , a selection list is presented to you with the following options:
•
Output : The port outputs data received from the network.
•
Input
1
: The port is configured as DMX input and sends data to the network.
•
Off : The port is turned off.
A bullet point is shown next to the currently active setting. Use the encoder wheel to select the desired setting and
push [OK] to apply the setting.
When setting multiple inputs to the same universe, the node will output the data depending on the used protocol:
•
Art-Net: Only one port will send data to the network, because Art-Net streams are identified by the IP
address.
•
sACN: All inputs can send data to the network, because sACN identifies every stream with an own ID.
Protocol
Under Protocol , you can choose between the following two options:
•
Art-Net : The port is using the Art-Net protocol for either input or output mode.
•
sACN : The port is using the sACN protocol for either input or output mode.
A bullet point is shown next to the currently active setting. Use the encoder wheel to select the desired setting and
push [OK] to apply the setting.
Output Settings
DMX Output Mode
The DMX Output Mode menu allows for choosing the DMX timing. This menu item has been introduced with
firmware version 0.99. Currently the following choices are available:
•
Max. Frame Rate (44 Hz)
•
Relaxed (30 Hz)
When Max. Frame Rate is selected, the DMX output signal has the following properties:
1
Input mode only available on devices produced after 2017 (hardware rev. 1.0-b)