Swisson XND-4D, Руководство пользователя

Страница: 13 / 34

13
The next number will become selected allowing you to configure the second number. Simply repeat the same steps
for the remaining numbers. After confirming the value of the last byte, the dialog will be closed, and the new
settings will be applied.
Netmask
In order to configure the netmask, use the same procedure as for configuring the IP address.
The netmask is used internally to compute the network address from the IP address. XND-4
does this by computing the bitwise AND of each byte with the corresponding byte of the IP
address. The bitwise AND of the first byte of the IP address and the first byte of the netmask is the first byte of the
network address and so on.
Gateway
In order to configure the default gateway address, use the same procedure as for configuring
the IP address or the netmask. If the network data sent by the node needs to be routed, you
may want to set this address to the address of your router. In most cases, however, this
setting is not relevant.
Set to Primary Art-Net IP
After navigating to the menu item Home > Menu > Network > Static Settings > Set to primary
Art-Net IP , a dialog as shown on the right will appear. Press [Cancel] to abort or press [OK] in
order to apply the following settings:
… Static Settings > I P Address is set to the primary Art-Net IP address (2.X.Y.Z). The values X, Y
and Z are computed from the device’s MAC address.
… Static Settings > Netmask is set to 255.0.0.0.
Set to Secondary Art-Net IP
As Set to Primary Art-Net IP , but sets network settings to the following values :
… Static Settings > IP Address is set to the secondary Art-Net IP address (10.X.Y.Z).
… Static Settings > Netmask is set to 255.0.0.0.
Art-Net Settings
Node-wide Art-Net settings can be configured under Home > Menu > Art-Net .
Art-Net Version
This section applies to firmware version 1.01 and later.
The menu entry Home > Menu > Art-Net > Art-Net Version provides the following selection:
•
Art-Net 4: Select Art-Net 4 to use the advantages of Art-Net 4. This is the recommended setting.
•
Art-Net 3: Select Art-Net 3 for backward compatibility.
A bullet point is shown next to the currently active setting. Use the encoder wheel to select the desired setting and
push [OK] to apply the setting.
When Art-Net 4 is selected, each output port has an independent port address in the range of 0 to 32767, which is
composed of an Art-Net net, sub-net and universe number. This allows for configuring the node to any combination
of Art-Net universes. When
Art-Net 3 is active, all ports of the node share the same net and sub-net numbers. For
more information on the addressing of the Art-Net ports, see section Representations of Art-Net Port Addresses in the
appendix.