Supero SUPERSERVER 6027B-TLF, Руководство пользователя

Страница: 51 / 106

Chapter 5: Advanced Serverboard Setup
5-21
LAN Port Enable/Disable
Use JPL1/JPL2 to enable or disable LAN
Ports 1 and 2 on the serverboard. See
the table on the right for jumper settings.
The default setting is enabled.
LAN Port En/Disable
Jumper Settings
Setting De fi nition
1-2 Enabled
2-3 Disabled
BMC Enable/Disable
JPB1 is used to enable or disable the
BMC (Baseboard Management Control)
chip to provide IPMI 2.O/KVM support.
The default position is on pins 1 and 2 to
Enable BMC. See the table on the right
for jumper settings.
BMC IPMI Enable/Disable
Jumper Settings
Setting De fi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
Watch Dog Enable
Watch Dog is a system monitor that can
reboot the system when a software appli-
cation hangs. Close pins 1-2 of JWD1 to
reset the system if an application hangs.
Close pins 2-3 to generate a non-mask-
able interrupt signal for the application
that hangs. See the table on the right for
jumper settings. Watch Dog must also be
enabled in the BIOS.
Watch Dog
Jumper Settings
Setting De fi nition
Pins 1-2 Reset (default)
Pins 2-3 NMI
Open Disabled
I 2 C Bus to CPU1/CPU2 VRMs
Use Jumpers JVRM_I
2
C1/JVRM_I
2
C2 to
connect the System Management Bus
(I
2
C) to the CPU1/CPU2 VRMs. The
default setting for the is on pins 1-2 to
enable the connection. See the tables on
the right for jumper settings.
I
2
C to VRMs (for X9DBL-3F/iF)
Jumper Settings
Jumper Setting De fi nition
Pins 1-2 Enabled
(Default)
I
2
C to VRMs (for X9DBL-3/i)
Jumper Settings
Jumper Setting De fi nition
Pins 2-3 Enabled
(Default)