Supero SUPERSERVER 6027B-TLF, Руководство пользователя

Страница: 37 / 106

Chapter 5: Advanced Serverboard Setup
5-7
5-5 Installing Memory
Note: Check the Supermicro web site for recommended memory modules.
CAUTION
Exercise extreme care when installing or removing DIMM modules
to prevent any possible damage.
Installing DIMMs
Insert the desired number of DIMMs into the memory slots, starting with slot P1-
DIMM#1A.
1. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
2. Align the key on the DIMM module with the receptive point on the slot.
3. Use two thumbs together to press both ends of the module straight down into
the slot until the module snaps into place.
4. Press the release tabs to the lock positions to secure the DIMM module into
the slot. See Figure 5-4.
Memory Support
The X9DBL-iF supports up to 192 GB of ECC DDR3-1600/1333/1066/800 RDIMMs/
LRDIMMs (RDIMM = Registered DIMMs, LRDIMM = Reduced Load DIMMs) or up
to 48GB of ECC UDIMMs (Unregistered DIMMs).
Figure 5-4. Installing DIMM into Slot
To Install:
Insert module
vertically and press
down until it snaps into
place. Pay attention to
the alignment notch at
the bottom.
To Remove:
Use your thumbs to
gently push the release
tabs near both ends of
the module. This should
release it from the slot.
Top View of DDR3 Slot
Release Tab
Release Tab
Note: Notch should align
with the receptive key
point on the slot.
Notch
Notch
Front View