Supermicro SC825M Series, Руководство пользователя

Страница: 52 / 88

SC825M(B) Chassis Manual
5-14
Figure 5-16. Riser Card Bracket
Expansion Card Setup in UIO/WIO Model Chassis
The configuration of the expansion cards in UIO/WIO models will vary, depending
upon if a Universal I/O card or WIO card is used:
With a UIO card:
Up to three full-height, half-length I/O may be used
Up to three low-profile PCI slots may be used.
With a WIO card:
Up to four full-height, half-length PCI slots may be used
Up to three low-profile PCI slots may be used.
Installing an Expansion Card in a UIO/WIO Model Chassis
1. Confirm that each add on card you are installing includes a standard "L" bracket.
If this is the first expansion card, start by locating the riser card bracket in your
chassis accessory bag and one or two riser cards, which are purchased sepa-
rately. One riser card accommodates the full-height expansion cards and the
other accommodates the three low profile expansion cards.
2. Power down the system and remove the power cords from the rear of the power
supplies as described in Section 5-2. Remove the chassis cover as described
in Section 5-3.
3. Attach the riser card(s) to the riser card bracket using screws. Note that there
are different cards for the right and left side of the bracket.
4. Insert the riser card(s) into the motherboard expansion slot(s) while aligning the
riser card bracket with the rear of the chassis. Secure the bracket with screws
(Figure 5-16).