Installation
900077-00, 01/2018
Innovative Hearth Products
DRL6500 Linear Direct-Vent Gas Fireplaces
45
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Figure 41 - Noncombustible Material with Bezel and Barrier
Figure 42 - Wall Receiver Switch
Remote
Off
On
PRG
Three-position slider switch in REMOTE
position
Figure 43 - Remote Control Transmitter
Hot Fireplace Will Cause
Severe Burns
Never Allow Children to
Touch Glass or other Fire-
place Parts
WARNING
LCD Display
ON/OFF Key
ROOM
TEMPERATURE
Key
UP/DOWN
Arrow Key
MODE Key
Initialize the Remote Control System
After completing fireplace installation, initialize the remote control system before operating the fireplace.
1.
Insert the three (3) provided
AAA
batteries into the battery bay in the remote control (
Figure 43
). Correctly align polarity (+/–).
2.
Insert the (4) provided
AA
batteries into the receiver battery bay (behind the wall switch plate). Correctly align polarity (+/–).
3.
Position the wall switch receiver three-position slider switch in the REMOTE position (
Figure 42
).
4.
On the wall switch receiver cover plate, insert the end of a paper clip (or other similar small object) into the hole
marked
PRG
(
Figure 47
). The receiver will beep three (3) times to indicate it is ready to synchronize with the
Remote control.
5.
On the remote control, press the ON button (
Figure 43
).
NOTE:
The wall switch receiver will beep four (4) times to indicate acceptance of the remote control command
(and set the Receiver to the Transmitter’s specific code).
6.
See
Page 55
for information on remote control operation.
Surround mounting
brackets (provided
with surround kit)
Clean
Face Frame
(removed first)
Bezel and Barrier
(added after Surround
- not shown)
One (1) Top non
-combustible
board
Clean
Face Frame
(removed first)
