Operation
900994-00K, 07/2021
Innovative Hearth Products
DRL2000 & DRL3500 Series Direct-Vent Gas Fireplaces
59
CAUTION
1/2” minimal gap from pilot cover to burner is required.
3. Place up to two layer of glass media on front perforated sections in front of burner
(
Figure 46
)
.
4. Place an even layer of glass over burner
(
Figure 47
)
.
5. Remove sticker and carefully place glass on pilot cover. Make certain not to drop glass down in-between pilot cover and burner
(
Figure 48
)
.
NOTE:
As crushed glass varies in size and installation, it may be necessary to add or remove small amounts of glass
to the burner to achieve the desired flame appearance.
Figure 46 - Placing up to two Layer of Glass Media.
Figure 48 - Removing Sticker and Placing Glass Media Over Pilot Cover.
Figure 47 - Placing a Single Layer of Glass Media over burner.
Pilot
Cover
Two Layer
of Glass
Media
Single Layer of Glass
Media over burner
Glass Media Over
Pilot Cover
1/2”
Minimal Gap
Required
f i r e - p a r t s . c o m