Installation
900994-00K, 07/2021
Innovative Hearth Products
DRL2000 & DRL3500 Series Direct-Vent Gas Fireplaces
26
Figure 18 - Elbow Heat Shield
Elbow Heat Shield (35” & 45” 3500 series Models Only)
If using a 90 degree elbow directly off fireplace, the elbow shield is required. Install per instructions in
Figure 18
.
NOTE:
Same installation applies if installed in a corner.
STEP 1
. Locate the two (2) flat elbow
shields.
STEP 2
. Bend the three (3) tabs 90
degrees as shown below.
STEP 3
. Attach the two (2) shields, as
shown, with screws.
STEP 4
. Attach the two (2) shields to the fireplace.
STEP 5
. Fold down tab to support rear of shield.
NOTE:
35” & 45” model = Strongly recommend at
least 1 ft of vertical rise directly off top of unit.
55” = 1 ft of vertical rise is required directly off unit.
f i r e - p a r t s . c o m