Super Circuits avsi-10, Руководство по установке и эксплуатации

Страница: 17 / 56

13 AVSI-10 Interview Room System Setup and User Guide
SECTION 3: SYSTEM SETUP
4. Anchor the backing plate to the AVSI switch mounting location with appropriate fasteners (not provided). Several screw
holes are provided in the backing plate. Use at least two fasteners.
5. Connect the CAB-SWITCH cable to the switch as follows:
a. Route the CAB-SWITCH cable from the mounting location to the recorder back panel.
b. Remove about 2” of insulating sheath from the end of the cable.
Insulating sheath
removed here
CAB-SWITCH
cable
c. Unravel the red-black pair from the green-white pair, then strip 1/4” of insulation from each of the four wires using a
22 gauge wire stripping tool.
d. Using a 1/8” wide blade screwdriver, loosen the four screw-down terminals on the backing plate board for the 12VDC
Input and DVR (recorder) Trigger .
e. Insert wires into the four terminal one at a time as follows. For each, screw in the terminal screw until the wire cannot
be pulled out easily.
i. Insert the red wire into the 12VDC Input “ + ” terminal.
ii. Insert the black wire into the 12VDC Input “ – ” terminal.
iii. Insert the white wire into either terminal of the DVR Trigger .
iv. Insert the green wire into the other terminal of the DVR Trigger .
6. Re-attach the box to the backing plate with the cables routed through the knockout and the 12VDC Output cable connector
contained within the box. Use the two Phillips screws removed earlier. See the photo below.