Sunerg Solar Energy Calor Top 200D, Инструкция по установке и эксплуатации

Страница: 16 / 42

16
Electric connection

If the power supply is not earthed well, the unit should be not installed.

The reliable earthing connection and the installation of the unit should be done by a
qualified person.

The power supply should be an independent circuit with rated voltage.

An all-pole disconnection device which has at least 3mm separation distance in all pole and
a residual current device (RCD) with the rating of above 10mA shall be incorporated in the
fixed wiring according to the national rule.

Set the electric leakage protector according to the relevant electric technical standards of
the local.

The power cord and the signal cord shall be laid out neatly and properly without mutual
interference or contacting the connection pipe or valve.

After wire connection, check it again and make sure the correctness before power on.
Specifications of power supply
Model name Calor Top 200D
Power supply 220-240V~, 50Hz, 1Ph
Min. diameter of power supply cord (mm
2
) 4
Earth cord (mm
2
) 4
Manual switch capacity (A)/Fuse (A) 25/20
Creepage breaker 30Ma, ≤ 0.1sec

Choosing the power cord according to above table, and it should comply with local electric
standard.

The power cord model, recommended power cord mode is H05RN-F.