Sundance Spas 780 series, Руководство пользователя

Страница: 2 / 76

Attention New Spa Owner!
Congratulations on the purchase of your new Sundance® 780 Series spa! The
following is a list of automated functions and maintenance recommendations
for your new spa. Automated functions have been listed below in an attempt to
suppress any operational concerns you may have during startup and the first 24
hours of ownership! Maintenance recommendations are listed in an attempt to
stress their importance in protecting your new spa. Spa operation and function
are subject to change without notice.
Automated Operations
Your new hot tub is equipped with an automated “clean-up” cycle that clears all
plumbing lines daily to promote maximum water sanitation. Each day at 12:00 PM
(noon), each pump will activate and run for one minute. If either pump has just
finished a 20 minute time out, it will not automatically activate for the clean-up cycle.
Note: Turning off the corresponding jets pump that is running can deactivate
the feature.
Maintain Healthy Spa Water
Always maintain your hot tub’s water chemistry within the following parameters:
with CLEAR RAY® without CLEAR RAY
pH 7.4-7.6 7.4-7.6
Free chlorine no less than 1.0 ppm 3.0-4.0 ppm
Free Bromine no less than 2.0 ppm 2.0-4.0 ppm
Total Alkalinity 100-150 ppm 100-150 ppm
Calcium Hardness 150-250 ppm 150-250 ppm
IMPORTANT:
CLEAR
RAY
® Water Purification System is factory installed. If
the CLEAR RAY ® system is altered or is not operating efficiently then follow
the “without CLEAR RAY ®” water chemistry parameters as defined by the
Association of Pool and Spa Professionals. CLEAR RAY ® requires an annual
bulb replacement to properly sanitize your water.
!
TO DECREASE RISK OF INFECTION OR DISEASE!
Always main-
tain your spa filter as outlined below to ensure healthy spa water. Refer to pages
38-39 for additional information.
Required Filter Maintenance
Your new hot tub is equipped with an advanced 2-stage MicroClean® water
filtration system that provides unsurpassed water quality! To ensure maximum
water quality at all times, you should clean and reuse the larger pleated filter
cartridge every month and replace (throw away) the smaller MicroClean filter
cartridge every 3 months, or earlier as necessary. The smaller MicroClean filter
cartridge is designed to be thrown away! Attempts to reuse this filter cartridge
may result in the re-release of unwanted particles back into the spa. See pages
38-39 for detailed filter cartridge replacement instructions.
Required Water Maintenance
!
TO DECREASE RISK OF INFECTION OR DISEASE!
You should
replace the spa’s water every 3 months. The frequency depends on a number
of variables including frequency of use, number of users, and attention paid
to water quality maintenance. You will know it is time for a change when you
cannot control sudsing and/or you can no longer get the normal feel or sparkle
to the water, even though the key water balance measurements are all within the
proper parameters. See pages 45-46 for additional information.