Sundance Spas 780 series, Руководство пользователя

Страница: 38 / 76

Page 32
780 Series
A. Programming the Primary Filtration Cycle
To change the programmed Primary Filtration Cycle:
Note:
If no button is pressed within 5 seconds of each
selection the screen will revert back to the Main Menu and the current
settings will remain active.
1. Press
until you get to the “ PF” Menu. The display will scroll
“ PRIMARY FILTER.” After the second scroll, if no action is taken,
the system will revert back to the Main Menu.
2. Press or to display the current start time and prepare the
system for changes.
3. Press or to adjust the start time, in 1-hour increments. To
switch from “AM” to “PM” you must round a 12-hour period.
4. Press 1 to confirm and save the start time.
5. Press or to adjust the duration of cycle, in 1-hour
increments.
6. Press
1
to confirm and save the duration time. The system will
return to the “
PRIMARY FILTER”
Menu.
In extreme bitter cold weather, where freezing can occur, we
recommend you program the primary filtration cycle to run 24
hours. Refer to the “Winterizing” section on page 43.
10.2 Secondary Filtration Menu
The jets pump 1 activates during the secondary filtration to provide
additional skimming. The hot tub is programmed with a default setting
of Holiday Mode, but can be programmed to other modes. There are 3
different modes, Holiday, Light and Heavy Mode.
Note: During the secondary filtration the jets pump 1, circulation pump
and CLEAR
RAY
are activated.
For Dover models only (uses pump 1 low speed):
• Holiday Mode disables the Secondary Filtration.
• Light Mode will activate two 30-minute cycles every other day ; one
at 8:00 AM and the other at 8:00 PM.
• Heavy Mode will activate two 30-minute cycles every day ; one at
8:00 AM and the other at 8:00 PM.
For all other models:
• Holiday Mode disables the Secondary Filtration.
• Light Mode will activate two 10-minute cycles every other day ; one
at 8:00 AM and the other at 8:00 PM.
• Heavy Mode will activate two 10-minute cycles every day ; one at
8:00 AM and the other at 8:00 PM.
A.
Programming the Secondary Filtration Cycle
To change the programmed Secondary Filtration Cycle:
Note: If no button is pressed within 5 seconds of each
selection the screen will revert back to the Main Menu and the current
settings will remain active.