Sun Microsystems Ultra 5, Руководство по обслуживанию

Страница: 184 / 258

A-8 Sun Ultra 5 Service Manual • February 2000
A.5.6 CD Handling and Use
The following topics are discussed in this section.
■
Inserting a CD into the CD-Rom drive
■
Ejecting a CD from the CD-ROM drive
■
Cleaning the CD-ROM drive
■
Handling and storing CDs
A.5.6.1 Inserting a CD into the CD-ROM Drive
1. After the system is powered on, push the eject button to open the drive tray.
It may be necessary to unmount the CD before manually ejecting it. The CD can also
be ejected by using software commands. Refer to the peripherals handbook that
corresponds with your operating environment.
2. Place the CD (label side up) into the tray.
Ensure that the CD is properly set into the recessed area of the tray.
3. If the drive is being installed in a vertical position, slide the two bottom tabs on
the tray toward each other to hold the CD.
A.5.6.2 Ejecting a CD From the CD-ROM Drive
To eject a CD, press the eject button on the front of the CD-ROM drive.
If the motorized eject mechanism does not operate, insert a thin, stiff wire (such as a
paper clip) into the hole next to the eject button to eject the CD.
A.5.6.3 Cleaning the CD-ROM Drive
If the CD-ROM drive cannot read a CD, the cause may be a dirty CD. Follow these
guidelines to clean a CD:
Caution – Do not user solvents such as benzine, paint thinner, antistatic aerosol
spray, or abrasive cleaners to clean CDs.
■
Use a soft, clean, lint-free, dry cloth.
■
Clean the non-labeled side of the CD.
■
Wipe the CD radially from the center to the outside.
■
Use professional cleaning kits.