Sun Microsystems Ultra 5, Руководство по обслуживанию

Страница: 158 / 258

8-12 Sun Ultra 5 Service Manual • February 2000
b. Insert the PCI card connector so that it touches the associated PCI riser board
connector.
Caution –
Support the riser card with the fingers of one hand, to insure full
insertion of the PCI card into the PCI riser board.
Caution – The PCI card bracket tab end must be inserted under the raised retaing
tab on the back of the system chassis (
FIGURE 8-5
).
c. Guide the PCI card bracket tab into the chassis back panel slot.
d. At the two corners of the card, push the card into the PCI riser board connector
until the card is fully seated.
e. Using a No. 2 Phillips screwdriver, replace the screw securing the PCI card
bracket tab to the system chassis.
3. Replace the PCI card into PCI slot 2 as follows (
FIGURE 8-5
):
a. Position the PCI card into the chassis.
b. Insert the PCI card connector so that it touches PCI riser board connector 2.
Caution –
The PCI card backplate end must be inserted between the card bracket
tabs in slots 1 and 3 (opposite side of riser card) and the raised retaining tab on the
back of the system chassis (
FIGURE 8-5
).
c. Guide the PCI card bracket tab into the chassis back panel slot.
Caution –
Support the riser card with the fingers of one hand, to insure full
insertion of the PCI card into the PCI riser board.
d. At the two corners of the card, push the card into the PCI riser board connector
until the card is fully seated.
e. Using a No. 2 Phillips screwdriver, replace the screw securing the PCI card
bracket tab to the system chassis.
4. Connect all external cables to the PCI card.
5. Detach the wrist strap, replace the system cover, and power on the system as
decribed in Chapter 10.