Sun Microsystems Sun Fire T200, Руководство по установке

Страница: 23 / 80

Chapter 1 Preparing for Installation 3
If you ordered any options that are not factory-installed, see the Sun Fire T2000
Server Service Manual for installation instructions.
Note –
The list of optional components can be updated without notice. Refer to the
Sun
SM
Store web site (
http://store.sun.com
) for the most current list of
components supported in the Sun Fire T2000 server.
ESD Precautions
Electronic equipment is susceptible to damage by static electricity. Use a grounded
antistatic wriststrap, footstrap, or equivalent safety equipment to prevent
electrostatic damage (ESD) when you install or service the Sun Fire T2000 server.
Caution –
To protect electronic components from electrostatic damage, which can
permanently disable the system or require repair by Sun service technicians, place
components on an antistatic surface, such as an antistatic discharge mat, an antistatic
bag, or a disposable antistatic mat. Wear an antistatic grounding strap connected to
a metal surface on the chassis when you work on system components.
Installation Overview
This installation guide provides procedures which are to be performed in the
following order.
1. Verify that you have received all of the components that ship with your server.
See “Shipping Kit Inventory List” on page 2 .
2. Gather configuration information for your system. See your system administrator
for specific details, including these parameters:
■
Netmask
■
IP address for the system controller
■
Gateway IP address
3. Install any optional Sun™ components shipped with your system. If you have
purchased other optional components such as additional memory, install them
prior to mounting the server in a rack. See
“Optional Component Installation” on
page 2 .