Sun Microsystems Sun Fire T200, Руководство по установке

Страница: 24 / 80

4 Sun Fire T2000 Server Installation Guide • April 2006
4. Mount the server into a rack or cabinet. See “Installing the Server in a Rack” on
page 11 .
Note –
In the rest of this manual, the term rack means either an open rack or a
closed cabinet.
5. Connect the server to a serial terminal or a terminal emulator (PC or workstation)
to display system messages. See “Powering On the System for the First Time” on
page 35 .
Tip –
The serial terminal or a terminal emulator should be connected before you
connect the power cables, or you will not see the system messages.
6. Connect the data cables to the server, but do not connect the AC power cable yet.
See “Connecting Cables to the Server” on page 27 .
7. Connect the AC power cable to the server and examine the display for any error
messages. See “Powering On the System for the First Time” on page 35 .
Caution – There is a potential for electric shock if the server and related equipment
are not properly grounded.
Note –
The system controller (SC) runs on the 3.3v standby voltage. As soon as AC
power is connected to the system, the system controller immediately powers on,
runs diagnostics, and initializes the ALOM-CMT firmware.
8. After the system controller boots, access the ALOM-CMT command line interface
through the serial management port. See “To Log Into the System Controller
Using the Serial Management Port” on page 38 .
9. Configure the SC network addresses. See “To Configure the System Controller
Network Management Port” on page 39 .
Note –
The SC network management port is not operational until you configure
network settings for the system controller (through the SC serial management port).
10. Enable the new configuration by resetting the system controller. See “To Reset
the System Controller” on page 42 .
11. Power on the server from a keyboard using the ALOM-CMT software. See “To
Power On the System” on page 44 .