Sun Microsystems Sun Fire T200, Руководство по установке

Страница: 55 / 80

35
C H A P T E R
3
Powering On the System
This chapter includes instructions for booting the Sun Fire T2000 system and for
enabling the system controller network management port.
The following topics are discussed:
■
“Powering On the System for the First Time” on page 35
■
“Enabling the System Controller Network Management Port” on page 38
■
“Logging Into the System Controller” on page 38
■
“Using the System Controller for Common Operations” on page 44
■
“Booting the Solaris Operating System” on page 47
Powering On the System for the First
Time
Tip – The serial terminal or a terminal emulator should be connected before you
connect the power cables, or you will not see the system messages. The server goes
into standby mode and the ALOM-CMT system controller initializes as soon as the
AC power cables are connected to the power source.
Note – If you are not logged in, ALOM-CMT times out after 60 seconds and reverts
to the system console. For more information, refer to the Sun Fire T2000 Server
Advanced Lights Out Management (ALOM) Guide .
The system controller runs on the 3.3v standby voltage. As soon as AC power is
connected to the system, the system controller powers on, runs diagnostics, and
initializes the ALOM-CMT firmware.