Chapter 4
Installing and Removing Devices
4-5
9. Install the trim strips (
FIGURE 4-1
).
Use a #2 Phillips screwdriver to tighten the captive screws.
10. If necessary, retract the stabilizer legs under the cabinet.
11. If necessary, close the front screen door.
If you formerly removed the door:
a. Tilt the door and insert the bottom hinge pin with outside hole of the bottom-
left mounting bracket.
b. Reach inside of the door and push down on the lever attached to the spring of
the top hinge pin.
This will cause the hinge pin to retract into the door.
c. Align the top hinge pin with the outside hole of the top-left mounting bracket.
d. Release the lever.
The hinge pin will extend into the mounting bracket.
4.4
Removing a Device
These instructions are meant to be used in conjunction with those that shipped with
the device you are installing. Read both procedures before beginning the installation.
Note –
If you are told to remove the side panels in the instructions that came with
your device, also perform the steps in Section 4.5 “Side Panel Removal and
Replacement” on page 4-7.
1. For cabinets equipped with a front screen door, open the front screen door.
If you want to remove the door:
a. Reach inside of the door and push down on the lever attached to the spring of
the top hinge pin.
This will cause the hinge pin to retract into the door.
