Sun Microsystems Netra 440, Руководство по обслуживанию

Страница: 80 / 166

62 Netra 440 Server Service Manual • August 2004
9. Disconnect the connector board power cable from the J18 connector on fan tray 3
(
FIGURE 4-8
).
Pull the cable out of the connector.
10. Disconnect the P1 DVD cable from the P1 connector on the motherboard
(
FIGURE 4-8
).
Lift up the connector ejector levers as far as they go to release the DVD cable end
from the connector, then pull the DVD cable out of the connector.
FIGURE 4-8
Locating J18 and P1 Connectors
11. Remove the PCI cards from the system, if necessary.
■
If short PCI cards are installed in the PCI slots at the rear of the system, you do
not have to remove them from the system. Go to Step 12 .
■
If long PCI cards are installed in the PCI slots at the rear of the system, you must
remove them from the system before you can remove the system configuration
card reader. See
“Removing a PCI Card” on page 86 for those instructions, then
return here.
Connector board power cable
DVD cable
P1 connector
J18 connector
Fan tray 3 assembly