Summa SummaSign D1010, Руководство по обслуживанию

Страница: 32 / 151

Service Manual SummaSign series Cutters
MEDIA SENSOR
The MEDIA SENSOR submenu is used to activate or deactivate the media sensors.
On the LCD, the active setting is marked with an *.
The sensors detect whether media is loaded or detect the end of media. The sensors
prevent damage to the cutting strip and knife tip.
AUTOLOAD
The AUTOLOAD option enables the user to the change the vinyl unroll proceedings.
When AUTOLOAD is ON , the cutter will automatically unroll the vinyl when needed.
When the AUTOLOAD option is OFF, the operator himself should unroll enough media
before starting to cut.
The default setting is ON. The best results and performance are guaranteed when
using this setting. On the LCD display, the active setting is marked with
an *.
TOOL COMMAND
The TOOL COMMAND is used to determine whether the DM/PL and HP/GL pen/knife-
select commands (the P and SP commands respectively) are ignored or accepted.
When the TOOL COMMAND option is set to “ACCEPT”, the P or SP commands will
change the selected tool in the cutter according to the suffix that follows the pen/knife
command. The cutter’s LCD will, e.g. prompt the user with the following message:
“INSERT PEN” when a P2 command is sent. When the TOOL COMMAND option is set
to “IGNORE”, the pen/knife commands are ignored.
On the LCD, the active setting is marked with an *. The default setting is “ACCEPT”.
LOAD ON W COMMAND
The LOAD ON W CMD submenu will only be displayed if the PLOT LANGUAGE is set
to DM/PL (See Paragraph 1.4.4.). The LOAD ON W CMD determines, when receiving
the DM/PL Window-command (W-command), whether aside from the scaling function,
media is loaded or not. Besides scaling, the W-command is also very useful when
cutting long signs. With the W-command, media loading will go smoother. Sufficient
media will be pulled off the roll at once. Even when AUTOLOAD is off, there is no need
anymore to unroll the media manually.
Keyboardcontrols 1-17