Summa SummaSign D1010, Руководство по обслуживанию

Страница: 17 / 151

SummaSign series Cutters Service Manual
THE LIQUID CRYSTAL DISPLAY
The 32-character liquid crystal display (LCD) contains two lines of 16 characters each.
The LCD provides cutter status information during operations and displays menu
options for the configuration of the cutter.
The contrast of the LCD can be adjusted from the control panel in order to ensure
optimum readability under varying lighting conditions.
Instructions for adjusting the LCD contrast are given in Section 1.6.12.
The various menu and submenu items are always presented in a loop, which means
that, when the last menu or submenu item is displayed, pressing the appropriate key
will automatically take you back to the first item of the same menu or submenu.
Next to the status messages and/or menu options displayed on the LCD, arrow
symbols representing the , , , jogging keys and key will tell
you what keys to press to go to the next menu item (top line of the display) or to the
next value for a given submenu item (bottom line of the display).
THE RESET/LOAD KEY
The key (RESET/LOAD) is used to move the origin, to initiate a load sequence, to
reset the cutter, to abort the cut in progress or to recut the last file. When the key
(RESET/LOAD) is pressed, the cutter goes off line, suspends all operations in
progress and displays the RESET/LOAD menu. Press the key until SET ORIGIN,
LOAD, RESET, ABORT or RECUT is displayed. To confirm RESET, ABORT or
RECUT press the
key (ENTER). To execute the SET ORIGIN instruction move
the knife origin using the , , , jogging keys and press the key (ENTER)
to confirm the new origin position. To initiate the LOAD instruction press the 1 or 2 key
to initiate a load sequence for a ROLL or SHEET respectively. Upon termination of any
of these instructions, the cutter goes on line again.
The SET ORIGIN instruction is used to move the knife origin.
The LOAD instruction is used to initiate a load sequence.
The RESET instruction performs a complete reset of the cutter.
The ABORT instruction simply cancels the cut in progress. Aborting a cut will not reset
the cutter parameters: the parameters which had been selected for the cut remain in
effect.
The RECUT instruction recuts the last file sent to the cutter (provided that it fitted into
the buffer).
When using the multiple recut function the different copies will be cut in the media in
such a way that there is only a minimal loss of media. The distance between the copies
can be changed (See Section 1.4.18).
THE ON LINE KEY
1-2 Keyboardcontrols