Summa SummaSign D1010, Руководство по обслуживанию

Страница: 15 / 151

SummaSign Service Manual
control, local mode for manual operation and menu mode. Each control panel
function is explained in Section 2.1.
5. Display : - The 2x16 character display informs the user about the current status
of the cutting process or actions which need to be taken.
6. Sensors : - The sensors detect the presence of media to avoid any damage to
the cutting strip. Upon powering up the machine, they cause the media to move
all the way to the front edge of the platen.
7. Pinch rollers : - The pinch rollers (one at each side) hold the media clamped
between the rubber rollers and the media drive sleeves.
The T1010 and T1300 units are provided with an extra low pressure roller in the
middle to keep the vinyl media flat.
8. Cutting strip : - Soft strip to avoid any damage to the knife tip when no media has
been loaded. Since cutting is done on the cutting strip it is essential that the
cutting strip remains intact.
9. Manual cut-off knife : - Upon completing a sign, move the media forward by
pressing the key. Use the manual knife to cut the finished sign off the media
roll. Leave the loaded media in place ready to start your next cut by pressing the
key again.
10. Stand : - The stand comes standard with the T1010 and T1300 units. For the
T610 and T750 units the stand is optional.
I-6 Introduction