Sumitomo TYPE-71c, Руководство по эксплуатации

Страница: 51 / 94

2-26
This section outlines fiber preparation procedures in using a fiber cleaver without single
fiber adapter (AP-FC6SA). If AP-FC6SA is available, please refer to the procedures 1.
1. Load the cable with its sheath
removed in the fiber holder.
Make sure that the cable sheath
touches the groove.
Close the bigger lid of the holder
first.
2. Remove the fiber coating at
2~4mm away from the edge of
the fiber holder. (Touch the
JR-M03 against the edge to
remove, and you can remove
the coating at 3mm away from
the edge.)
3. Clean the bare fiber from the
end of the fiber coating with a
gauze pad moistened with pure
alcohol. Pull the bare fiber
through the gauze pad and
rotate the fiber to remove any
coating residue.
5. Repeat step 1~4 for the other
cable.
Fiber preparation procedures 2 (AP-FC6SA is not available)
4. Place the fiber holder in the
cleaver, touching the edge of the
fiber holder against the edge of
the fiber holder receptacle.
Cleave the fiber referring to the
cleaver instructions.