Sumitomo TYPE-71c, Руководство по эксплуатации

Страница: 16 / 94

1-1
1. General
Thank you very much for purchasing the TYPE-71C MicroCore™ Fusion Splicer
(hereinafter called “the TYPE-71C”).
The TYPE-71C automatically pre-inspects and aligns a pair of optical single fibers with
equipped microscopes, and then fuses them together with heat from an electric arc to
form a low-loss splice. A protection sleeve is applied over the bare glass and cured in
the built-in heat shrink oven.
Before using the TYPE-71C, read all instructions completely.
Read this manual carefully in its entirety to fully understand
machine capabilities. Save this manual in a location in which you
can easily get to see.
Product overview
The TYPE-71C can splice the following optical fiber types.
Material Silica glass
Profile type
SMF (ITU-T G.652), MMF (ITU-T G.651),
DSF (ITU-T G.653), CSF (ITU-T G.654),
NZDSF (ITU-T G.655, G.656), BIF (ITU-T G.657), EDF
Fiber diameter 80 - 150 μ m *1
Fiber coating diameter 100 - 1,000 μ m
Fiber count Single fiber
Cleave length *2
5 - 16mm （ Over 250 μ m coating diameter with the
length less than 8mm requires fiber holder operation.
）
*1 Fiber diameter except 125 μ m are only applied in the factory temperature and 0m altitude.
*2 The applicable fiber protection sleeves vary depending on the cleave length.
The TYPE-71C key features are:
・
Touch screen monitor
(For more information, refer to page 2-8.)
4.1 inch LCD monitor with touch screen operation enables to confirm fiber images
easily. The splicer can be operated by touching the icons on the screen. The
working efficiency has improved dramatically.
•
Dual heat shrink oven
(For more information, refer to page 2-20, 5-2.)
Following the conventional model TYPE-39, 2 heat shrink ovens are equipped with
the fusion splicer. The ovens run individually and splicing operation can be
improved more effectively.
Optical fiber requirement
Features overview
Caution