SUHNER MACHINING BEA 16, Техническая документация

Страница: 40 / 60

Signal definition:
- An alternating signal (500 ms high / 500 ms low) is emit-
ted.
- A malfunction is triggered if no positive or negative edge
has been perceived by the communication partner after
1000 ms.
3.5 f
unctiOn Of the terminAls
/t
erminAl
Assignment
<- (Input):
Terminal 110A2:00
Error Reset
Terminal 110A2:01 Program Start
Terminal 110A2:02 Program Stop
Terminal 110A2:03 Single step On/Off
Terminal 110A2:10 Basic position Start
Terminal 110A2:11 Tool change Start
Terminal 110A2:12 Single step Start
Terminal 110A2:13 Toggle Bit
Terminal 110A2:20 User Input
Terminal 110A2:21 User Input
Terminal 110A2:22 User Input
Terminal 110A2:23 User Input
Terminal 110A2:30 User Input
Terminal 110A2:31 User Input
Terminal 110A2:32 User Input
Terminal 110A2:33 User Input
>- (Output):
Terminal 110A6:00
Error pending
Terminal 110A6:01 Program Ready
Terminal 110A6:02 Program Done
Terminal 110A6:03 Program Error
Terminal 110A6:10 Basic position
Terminal 110A6:11 Tool change active
Terminal 110A6:12 Single step Ready
Terminal 110A6:13 Toggle Bit
Terminal 110A6:20 User Output
Terminal 110A6:21 User Output
Terminal 110A6:22 User Output
Terminal 110A6:23 User Output
Terminal 110A6:30 User Output
Terminal 110A6:31 User Output
Terminal 110A6:32 User Output
Terminal 110A6:33 User Output
3.6 c
OntrOl
Instead of the higher-level control, the movements
can be made directly via the SUHNER HMI. The
safety requirements (E-STOP) must be observed!
3.7 t
OOls
Handle tools and attachments with care, keep
them clean and sharp, and observe the manufac-
turer’s instructions on the use of coolants and tool
receivers.
Use the attachments intended for each application. Do
not trim attachments for applications they have not been
designed for.
Always use speeds and feed rates assigned to the attach-
ment and material, and do not exceed the machine’s max
speed.
Never remove chips with your bare hand, but always use
e.g. hooks, etc.
3.8 n
Otes On OperAting sAfety
After disconnecting the machine from the power
supply, wait for at least four minutes before start-
ing work on the machine.
4. s
ErvicE
/m
aintEnancE
4.1 p
reVentiVe mAintenAnce
As soon as maintenance or repair work
starts, disconnect the machine from the
power supply, and secure it against acci-
dental reactivation.
4.1.1 g
reAsing
The machine must be greased every 300 operat-
ing hours.
The pinion must be at the reference point (1). 4g of Klüber
ISOFLEX NBU 15 (2). 7g of Klüber ISOFLEX NBU 15 (3).
After greasing, advance the pinion to 140mm, clean it,
and rub in oil that does not secrete resin.
4.1.2 e
xAmining the Belts And luBricAting the pOlygOn
shAft
The belts must be examined and the polygon
shaft must be lubricated every 900 operating
hours.
40
P
ortugúes
Español
Italiano
F
rançais
Deutsch
English