Torq-Tronics 2
® /
Owners Manual
5.2: LED Indicators
The Torq-Tronics 2 is equipped with 2 LED indicators: upper
left hand side of the label above the Display screen. Green
indicates the measurement is within target torque range.
Torq-Tronics 2 is equipped with two LED indicators on the
upper left hand side of the Display. The Torque Indicator
LED is engineered to give you additional visual feedback on
test results. However, if you have not established a pre-de-
termined test point, the Torque indicator LED will not light
during a test:
5.2.1
A Red/Green LED indicator labeled ‘Torque Indicator’ and a
Yellow indicator labeled ‘Low Power’, both are on the upper
left hand side of the label above the display screen.
5.2.2
Green indicates the measurement is within target specifications.
5.2.3
Solid Red: indicates measurement is outside of target specification.
5.2.4
Blinking Red: during a zero offset indicates the transducer offset is greater than 0.25%
of rated transducer capacity.
5.2.5
Constant blinking red indicates the transducer had a torque applied over 120% of rated
capacity. (Refer over capacity section in the manual on how to clear an over torque
condition.)
5.2.6
Blinking Yellow indicates a low power condition. If batteries are supplying power, it
may be time to recharge them.
Owners Manual
Torq-Tronics 2
Sturtevant Richmont
Direct: 1 847/455-8677
U.S. Toll-Free: 800/877-1347
www.srtorque.com
11
/16/201
7
REV
E
. Document Page 9 of 39