Sturtevant Richmont Programmable Torque Verifier FM II, Руководство пользователя

Страница: 29 / 37

Page 27
The ones column digit will begin flashing. Use the UP and DOWN keyswitches to display the
desired selection, then press the SET keyswitch to lock in the last digit and return to the
BATCH element. Press the UP keyswitch to go to the next element.
22.The LED Display will then scroll " CLEAR WRENCHES " from right to left. Press the SET
keyswitch to clear the wrenches from memory. Press the SET keyswitch a second time to fin-
ish clearing the memory. The LED Display will show a set of four rotating lines while the
memory is cleared. When this is completed, "DONE" will be briefly displayed, then the
"CLEAR WRENCHES" selection message will resume scrolling across the screen. To
advance to the next element, press the UP keyswitch.
23." CHANNEL SELECT " will start scrolling across the screen. Press the SET keyswitch to
access channel selection. The LED Display will then show " CH-N ", with "N" being the num-
ber of the current setting. To change the channel, use the UP or DOWN arrow keyswitch until
the desired channel is displayed. When the desired channel for communicating with the FM
Switch Wrench is shown on the LED Display, press the SET keyswitch, then press the UP
keyswitch to move to the next element.
24." MANUAL LEARN " will scroll across the LED Display. This is used to "teach" a new wrench
to the unit. To have the Generation II "learn" a new wrench, the wrench must be immediately
available and ready to be clicked. Press the SET keyswitch to begin the process. The LED
Display will then scroll the channel on which it is set, followed by the instruction "
CLICK
WRENCH ". The red SETUP LED will light. Click the wrench to be learned by the unit and
hold it in the “clicked” position until the Gen II emits a “chirp”. This must be done in five (5)
seconds or less. Then repeat the “click and hold” until a second “chirp” is heard. When the
wrench has been learned, "
GOOD " will be displayed, then the red SETUP LED will go out
and " MANUAL LEARN " will resume scrolling across the LED Display. If no click is received
on the selected channel in five seconds or less, the unit will exit the learning mode, the red
SETUP LED will go out, and "
MANUAL LEARN " will resume scrolling across the LED Display.
Teaching a wrench to the unit may be re-entered by pressing the SET keyswitch, or you can
advance to the next element by pressing the UP keyswitch.
25.The next element is " AUTO LEARN " which will scroll across the LED Display. To enter the
AUTO LEARN function, press the SET keyswitch. The instruction to "CLICK WRENCH" will
appear, and the red SETUP LED will light. Click the wrench to be learned twice, holding it in
the “clicked” position each time until a beep is obtained and the channel number followed by
"
GOOD " appear scrolling across the LED Display. This function is somewhat different from
the MANUAL LEARN function, in that it checks channels as well as for the wrench. When
completed, the display will resume scrolling "
AUTO LEARN ".