Sturtevant Richmont Programmable Torque Verifier FM II, Руководство пользователя

Страница: 23 / 37

Page 21
Changing the Power Setting
A. Obtain a flat tip screwdriver.
B. Locate the Power Entry Module on the lower half
of the right side of the PTV.
C. Insert the tip of the screwdriver under the Tab of
the Fuse/Voltage Selector Holder.
D. Gently pry the holder out to release it.
E. Once the holder is released, slide the holder com-
pletely out of the PEM.
F. The Voltage Selector & Indicator Card is a card
that can be removed by sliding it sideways out of
the holder. Remove the card from the holder by
sliding it gently out of its’ channel in the holder.
G. Turn the Voltage Selector & Indicator over so the
240V is upright and the 110V is upside down.
H. Reinsert the Voltage Selector and Indicator into
the holder in the new orientation. If the correct
voltage now shows in the window in the holder,
the operation has been properly performed. To
reinstall the holder into the Power Entry Module,
reverse the steps taken to remove it. When this is
complete, the module should appear as it did at
the start of the process, but with the corrected volt-
age showing through the window.