Sturtevant Richmont Programmable Torque Verifier FM II, Руководство пользователя

Страница: 26 / 37

Page 24
1. The number of fasteners on the assembly
2. The minimum acceptable time (duration) of signal for the joint.
3. The maximum acceptable time (duration) of signal for the joint.
4. The minimum time required between wrench cycles (clicks).
5. The minimum time required between batches (groups of fasteners).
6. The channel on which the FM Switch Wrench for each parameter to be programmed is set.
7. Each FM Switch Wrench to be programmed into the unit must be readily available.
The maximum and minimum signal duration (click time) numbers are usually determined by
experimentation prior to programming for production. The steps contained in this section are
readily modified for experimenting prior to entering the production program.
Programming Steps
1. Assure PTV-FM is plugged into the appropriate power source.
2. Move the Power Switch to the On position.
The LED Display will show the following in sequence:
PTV
V 2.NN
Count
A. 0
Note that "A" is the selected parameter and "0" is the number of completed fasteners on the
assembly for that parameter.
3. Determine which of the four Parameters will be used, and rotate the Parameter Selection
Switch to that Parameter (A, B, C, or D).
4. Insert the Key into the Key Lock.
5. Turn the key to the PROG position. The following items will scroll across the LED Display in
sequence:
MENU OPTIONS - -
AUTO LEARN
(Repeats)
6. Press the SET keyswitch. The unit will then display:
CLICK WRENCH
7. Click the wrench to be used for this parameter at this station, holding the wrench in the
clicked position until a “chirp” is emitted by the Gen II. Separate the clicks by several sec-
onds.