Sturtevant Richmont 10469, Руководство по эксплуатации

Страница: 8 / 32

Page 6
To change the voltage selection:
1. Make certain that the power cord is disconnected from the receptacle on the unit.
2. Set the unit on a flat work surface.
3. The voltage selector is attached to the plastic
cover that has the window through which the
current voltage selection is displayed. This cover
is a “snap-in” or press-fit type; it is pressed into a
recess in the PEM. The cover must be removed
to access the voltage selector.
To remove the cover, insert a fingernail or small
screwdriver into the slot located in the power
receptacle behind the tab at the top of the cover
and pry outwards gently. See photograph at
right.
4. The photograph to the right shows
the voltage selector holder removed
from the PEM. The current setting is
for 120VAC, as shown in the holder
window.
The voltage selector itself is a yellow
and black plastic and metal compo-
nent, one corner of which is visible
and highlighted by the red arrow.