Sturtevant Richmont 10469, Руководство по эксплуатации

Страница: 10 / 32

Page 8
Four-Pin I/O Port Connection
This is a four-pin circular connector, Amphenol-Tuchel T3303 000. The relay pin connection
configuration is:
Pin 1 Cycle OK
Pin 2 Batch Complete
Pin 3 Cycle Reject
Pin 4 +24VDC
The unit arrives with +24VDC electric power supplied
on Pin 4. The system power at Pin 4 is rated at
+24VDC and 0.5 Amps. The voltage on Pin 4 will be
returned on pins 1 - 3 as the corresponding relays close.
RS-232 Nine-Pin DSUB Connection
This connector is used to communicate with an
external computer. There is software available
that permits programming the TCV-Ethernet via
serial communications through this port.
A null-Modem cable (or convertor and standard
cable) is required to connect this port to another
device.
For this connector:
Pin 2 - RX
Pin 3 - TX
Pin 5 - GND
The other pins are straight-through connections.
Ethernet Connection (RJ45 - 10BASE - T)
This port is used for connection to the plant floor control ethernet network. This unit will transmit
TCP/IP messages based on the PowerFocus Open Protocol directly to the plant floor system
each time a fastnening is communicated to the unit by the FM Switch Wrench.
Power Connection
Check the voltage selection to assure the voltage setting for the unit is the same as that being
supplied. If the two voltages match, connect the power cord to the power receptacle in the
Power Entry module.