49
© STULZ GmbH – all rights reserved EN/11.2018/G67C
wib8000 original instructions
A5.2 Router settings
As far as the router settings are concerned you can refer to the quickstart instructions provided.
If the login data for router administration or the IP parameters must be modified, select the items „Basic Set-
tings->Webinterface“ and „Basic Settings->IP addresses (LAN)“.
Modem
Depending on the fact whether a dial tone is available or not before dialing, the item „Wait for dial tone“ must
be set. The parameters under MODEM can only be changed, when "Dial-In" as well as "Dial-Out" are disabled.
To confirm click on „OK“ at the end of the page.
dial-In
If the dial-up from the telephone network shall be enabled, select "Yes" for "Enable dial-in" in the menu item
"Dial-in". The check mark for "Authentication for dial-in" should be set in addition and a user name/password
should be entered.
All other parameters can keep their default values as can be seen under 11.2.6 of the manual.
The check mark "enable NAT“ must be set (default). To confirm click on „OK“ at the end of the page.
After having finished these settings the WIB8000 should be accessible by the telephone network through
remote data transmission network (here: http://192.168.1.5).
dial-Out
If the WIB8000 shall be enabled to send emails, an automatic connection buildup must be configured in the
router under "Dial-Out“.
For the authentication at the remote station enter the following data:
• telephonenumber
• username
• password
and set the check marks for
• "requestDNSserveraddress“
• "enableNAT“.
All other parameters can keep their default values as can be seen under 11.2.7 of the manual.
To confirm click on „OK“ at the end of the page.
Forgot password
If you do not succeed in establishing a connection to the web interface of the router via Ethernet for a con-
sisting system, the cause may be an incorrect IP address or user name/password. In this case it is possible to
reset the router to the condition at delivery, by pressing three times the reset button within two seconds. See
manual 12.11.5 Reset. All settings done are lost in doing so.
