1-30
1900-009-001 REV B
En
gli
sh
Accessories
PROTECTIVE TOP WITH SUPPORTS INSTALLATION (FA64183-BIL)
The protective top was designed to close all possible openings about the safety rails.
WARNING
•
Remove the patient from the bed before installing the accessory.
•
If the stretcher on which the protective top will be installed is equipped with the Weigh system optional), ensure
you turn it off before undertaking the installation of the top. Once done with the installation, refer to the stretcher
Operations Manual to zero the scale.
Necessary Tools:
•
9/16 in. Wrench
Prodedure: (See figure 19)
Note: Two people are necessary to install the protective top.
1. Mount the four posts
into the two top plastic
structures the following
way: Press on the lock
pin located on the top
part of the post and insert
the post into one of the
four slots provided on the
plastic structures.
2. Ensure that the post is
securely locked in place
by checking that the lock
pin is positioned in the slot
provided on the outer side
of the plastic structure.
3. Install the four posts in the
accessory bracket sockets
and lock the posts in place
using the four hitch pins.
WARNING
It is very important for the
patient’s safety that the
whole assembly is thoroughly
inspected before use to ensure
it is properly and securely
mounted.
PLASTIC
STRUCTURE
P
LASTIC
S
TRUCTURE
POST
POST
PINS
PINS
ACCESSORY
BRACKETS
RELEASE
KNOBS
RELEASE KNOBS
LOWER RAIL
LOWER RAIL
POSITIONING FRAME
POSITIONING FRAME
ANCHOR
POINTS
ANCHOR POINTS
Figure 19