StreamLight FIRE VULCAN, Руководство по обслуживанию

Страница: 20 / 43

Paddle Switch/PCB Installation
Single Filament Assembly P/N 440008 Dual Filament Assembly P/N 440027
B. Reattach the leads to the charge contact screws and secure them in place.
1. The negative (black) lead goes to the charge contact screw on the left side (open
side of body facing upward, handle facing away from you) and the positive (red)
charge lead goes to the contact screw on the right.
2. Use a 5/16" wrench to tighten the lock-nuts until they are snug against the body.
When the contact screws are snug turn the Tri-Wing contact screw additional 1/8th
turn to insure a waterproof seal.
Note: Do not over tighten the screws, especially the older style hex screws, or the body
may crack.
C. Place the switch/PCB assembly onto the mounting posts in the Vulcan body.
Mounting Posts
1. The switch contact side of the assembly must face down. See picture on page 21
for proper orienteering.
2. Route the battery leads and charge leads between the mounting posts and the walls
of the body.
- 20 -