StreamLight FIRE VULCAN, Руководство по обслуживанию

Страница: 16 / 43

2. Route the battery leads and charge leads between the mounting posts and the walls
of the body.
3. Reconnect the battery leads and test the switch for function. After confirming the
switch functions properly, remove the battery leads and proceed to Step D
D. Replace the battery clamp above the battery, but do not secure it.
1. Route the positive battery and charge leads between the Vulcan body and the
battery clamp on the right side of the Vulcan (handle facing away from you).
2. Route the negative charge lead (only) between the Vulcan body and the battery
clamp on the left side of the Vulcan (handle facing away from you).
E. Secure the battery clamp into place with the two Phillips mounting screws.
F. Reattach the battery leads.
1. Attach the positive (red) lead to the positive battery terminal. (Note: Use needlenose
pliers if necessary.
2. Attach the negative (black) lead to the negative battery terminal.
G. Place the lamp into the lamp socket (Note: Detailed instructions are in Section ll).
H. Put the switch boot over the toggle switch and, using a 5/8” wrench, carefully tighten it
until it is snug.
I. Reassemble the Vulcan as described in Section l.
Toggle Switch with Boot
(Before Tightening)
Toggle Switch without Boot
- 16 -