Stratasys Eden350V, Руководство пользователя

Страница: 165 / 182

DOC-03050 Rev. A
6–59
Eden350V User Guide
7. Pull the lamp reflector out of the print block.
Figure 6-98: Removing the UV lamp reflector
8. Inspect the new lamp reflector, and make sure that a black strip is
attached to the inside of it. If not, install one—on the side of the
reflector opposite (not next to) the print block.
Note: Extra black strips are included in the printer Start-up Kit. If
necessary, you can remove the black strip from the old reflector and install
it in the new reflector (as long as the black paint has not faded).
9. Discard the old reflector and lamp.
Dispose of the used UV lamp in accordance with environmental and safety
requirements.
WARNING: Broken lamp hazard.
UV lamps contain mercury. Deal with broken lamps with caution.
¾
Ventilate the room thoroughly.
¾
Use protective gloves when collecting mercury and lamp components.
¾
Remove spilled mercury with a method that prevents the generation of
mercury vapor, such as a syringe, packing tape or paper.
¾
Place the broken lamp, mercury and contaminated materials in an air-
tight, non-metallic container.