Strand Lighting Contact Power Pack, Руководство по установке и эксплуатации

Страница: 27 / 48

Contact Power Pack Sensor System
Installation & Operation Guide
25
PROGRAMMING PHOTOCELL DAYLIGHTING
SENSORS
A Contact IR Remote Sensor Programmer is used to program the Photocell Daylighting Sen-
sor (61329). Refer to "Infrared (IR) Remote Sensor Programmer" on page 16 for a general
overview of this device.
Adjust Scene Dimmer Levels (Green)
A Scene’s dimmer levels may be set as required.
To adjust scene dimmer levels:
Step 1. Tap DSCN (E) button to select the Dimmer Scenes (refer to page 16 for IR Remote
button layout).
Step 2. Tap buttons to select the following scenes:
Note: Dimmers will go to their Last Set Scene Levels.
Step 3. Tap DMR S button to Select ‘Raise’ Dimmer Levels or Tap DMR T button to
Select ‘Lower’ Dimmer Levels.
Step 4. Press-Hold-Release buttons to Raise or Lower the level of the following Dimmers:
Note: When button it pressed the selected Dimmer Level starts to Raise or Lower. When the
button is released the dimmer stops.
Step 5. To save the new dimmer levels to a Scene Tap DSCN (E) button again then Press
and Hold the desired Scene button for 3 or more seconds:
Button 1 Scene 1 (Sets Max Dimmer Levels for Daylight Harvesting)
Button 2 Scene 2 (Sets Min Dimmer Levels for Daylight Harvesting)
Button 8 Scene 0 or Off Scene (Dimmers will always be set to Off)
Button 0 Factory Default (Scene 1)
Button 1 Dimmer 1
Button 2 Dimmer 2
Button 0 Dimmers1-2 (Master Raise/Lower – All Dimmers)
Button 1 Scene 1 (Sets Max Dimmer Levels for Daylight Harvesting)
Button 2 Scene 2 (Sets Min Dimmer Levels for Daylight Harvesting)
Button 8 Scene 0 or Off Scene (Dimmers will always be set to Off)
Button 0 Factory Default (Scene 1)