Strand Lighting Contact Power Pack, Руководство по установке и эксплуатации

Страница: 25 / 48

Contact Power Pack Sensor System
Installation & Operation Guide
23
Note: When button is pressed, the selected Dimmer Level starts to Raise or Lower. When the
button is released, the dimmer stops. The power pack will link the relay and dimmer together
(example: Relay 1 to Dimmer 1). When the Dimmer Level is set to 0 (off), the linked relay
will turn off.
Step 7. To save the new dimmer levels to a Scene Tap DSCN (E) button again then Press
and Hold the desired Scene button for 3 or more seconds:
Test
The Test feature allows testing of the system without having to wait extended periods of time
for the loads to time out.
While in Test Mode, the timer functions at a rate of 1/60th. A 30-minute time-out period
would become a 30-second time-out period with a 10 second minimum.
To enter Test Mode:
Step 1. Enter Programming Mode (refer to page 16).
Step 2. Press TEST button. All sensors in Test Mode will blink red (Test Mode), blue
(motion detected), or green (delaying to relay off).
Step 3. Confirm all sensors, relays and switches are working properly.
Step 4. Press TEST button again to exit Test Mode.
Note: Alternate between Test Mode and Programming Mode by pressing the TEST button
anytime during the process.
Button 1 Scene 1 (Sets Max Dimmer Levels for Daylight Harvesting)
Button 2 Scene 2 (Sets Min Dimmer Levels for Daylight Harvesting)
Button 8 Scene 0 or Off Scene (Dimmers will always be set to Off)
Button 0 Factory Default (Scene 1)