Strand Lighting Contact Power Pack, Руководство по установке и эксплуатации

Страница: 14 / 48

Installation & Operation Guide
Contact Power Pack Sensor System
12
LED Display
When in the Programming Mode, the LEDs display the following information:
• Red LED – Always On.
• Blue LED – Blinks 1 to 6 times to indicate the Field being displayed or set (see Field/
Setting Table on next page).
• Green LED – Blinks 1 to 9 times to indicate the present setting of the Field (see Field/
Setting Table on next page).
Field/Setting Table:
* Factory Default
To set a Field:
Step 1. After entering the Programming Mode, the Field LED (Blue) will blink one time
(Field Set), display the present setting ( green blinks), and then repeat the pattern.
Step 2. Each press of the Field Button will select the next Field.
Step 3. Pressing the button after the last field will exit the Programming Mode.
Step 4. Once the Field is selected (proper number of blue blinks), press the Setting Button
one or more times to change the Field setting. Verify by observing the number of
blinks.
Step 5. Once the Field is selected (proper number of blue blinks), pressing and holding the
Setting Button for 3 seconds will set the Factory Default for that Field.
Notes:
Each tap of the Setting Button will advance the setting by one. Example: Three taps sets the
Field setting to 3 (taps must be less then 2 seconds apart).
After 2 or more seconds following the last tap, the Setting Button will reset back to 1 with the
next tap. Example: Three taps, delay of 2 or more seconds, and then two taps will set the Field
setting to 2.
Blue Blinks - Field Green Blinks - Setting
1 - Mode
1 - Aggressive Intelligence
2 - Normal Intelligence
3 - Conservative Intelligence
4- Fixed Timing *
2 - Manual/Automatic 1 - Manual, 2 - Automatic *
3 - Time
1 - 1 min, 2 - 3 min, 3 - 5 min, 4 - 10 min
5 - 15 min *, 6 - 20 min, 7 - 25 min, 8 - 30 min
4 - Relay/Dimmer Select
1 - Relay/Dimmer 1, 2 - Relay/Dimmer 2, 3 - Relay/Dimmer 3,
4 - Relay/Dimmer 4, 9 - All Relays/Dimmers *
5 - Sensitivity 1 - Low, 2 - Medium *, 3 - High
6 - Photocell On
Sensitivity
1 - Low, ...7 High, 8 - Disabled *