11
SP 81
English
:
Place the clamp (
7
) in the loop
handle (
3
) and position them both
against the drive tube (
8
).
:
Fit the clamp (
9
) and place the
barrier bar (
6
) on the handle,
making sure it is positioned as
shown.
:
Line up the holes.
:
Insert the screws (
10
) in the holes
and screw them into the barrier bar
as far as stop.
:
Go to “Adjusting the handle”.
Mounting loop handle without
barrier bar
:
Place the clamp (
7
) in the loop
handle (
3
) and position them both
against the drive tube (
8
).
:
Fit the clamp (
9
) and line up the
holes.
:
Fit the washers (
11
) on the screws
(
10
) and insert the screws in the
holes. Screw them into the square
nuts (
5
) as far as stop.
:
Go to “Adjusting the handle”.
Adjusting the handle
:
Line up the handle and adjust it to
the most favorable position for the
user and application.
Distance
A
must not be more than
55 cm. About 35 cm is
recommended.
:
Tighten down the screws on handle
firmly.
Removing the handle
It is advisable to remove the loop
handle to use the basic power tool
for its original purpose.
:
Remove the loop handle and keep
all the parts in a safe place for future
use.
