Stihl BT 360, Инструкция по эксплуатации

Страница: 20 / 28

BT 360
English
18
Changing Gearbox Oil
Drain the oil while it is at normal
operating temperature.
N
Position the gearbox so that the
drilling spindle is vertical and points
downwards.
N
Take out the inspection plug (1).
N
Collect the gearbox oil in a suitable
container.
N
Dispose of old oil properly in
accordance with local regulations.
N
Fill the gearbox with fresh oil as
described under "Checking Oil
Level / Refilling".
To help prolong the wear life of the
starter rope, observe the following
points:
N
Pull the starter rope only in the
direction specified.
N
Do not pull the rope over the edge of
the guide bushing.
N
Do not pull out the rope more than
specified.
N
Do not allow the starter grip to snap
back, guide it back into the housing
slowly – see chapter on "Starting /
Stopping the Engine."
Have a damaged starter rope replaced
by your dealer before it breaks
completely. STIHL recommends that
you have servicing and repair work
carried out exclusively by an authorized
STIHL servicing dealer.
For periods of 3 months or longer
N
Remove the drilling tool.
N
Drain and clean the fuel tank in a
well ventilated area.
N
Dispose of fuel properly in
accordance with local
environmental requirements.
N
Run the engine until the carburetor
is dry – this helps prevent the
carburetor diaphragms sticking
together.
N
Thoroughly clean the machine – pay
special attention to the cylinder fins
and air filter.
N
Store the machine in a dry, high or
locked location, out of the reach of
children and other unauthorized
persons.
Rewind Starter Storing the Machine