Stihl BT 360, Инструкция по эксплуатации

Страница: 17 / 28

BT 360
English
15
If the auger jams in the hole – shut off the
engine immediately.
N
Move the stop switch on the
handlebar to 0.
N
Move the stop switch on the
powerhead to STOP.
N
Swing the interlock lever (1) to the
left to block the gearbox.
N
Rotate the whole machine
counterclockwise to unwind the
auger from the ground.
The interlock lever is designed to
disengage automatically if the maximum
unwinding torque is exceeded. This
reduces the risk of damaging the drilling
gear.
If there is a noticeable loss of engine
power
N
Pull out the choke knob (1).
N
Loosen the twist lock (2) on the filter
cover.
N
Remove the filter cover (3).
N
Clean away loose dirt from around
the filter and inside the filter cover.
N
Inspect the main filter (4).
If it is dirty or damaged:
N
Unscrew the end cover (5) with
wingnut.
N
Remove and replace the main filter.
Always install a new auxiliary filter
together with the new main filter.
N
Inspect the auxiliary filter (6) – if it is
dirty, knock it out on the palm of
your hand – if it is damaged, install a
new one.
When removing the auxiliary filter take
care to ensure that no dirt falls into the
intake.
N
Clean the filter box – reassemble all
filter components.
N
Refit the filter cover.
N
Tighten down the screw.
N
Push in the choke knob.
Releasing a Trapped Auger
441BA069 KN
441BA070 KN
1
Cleaning the Air Filter
2
1
3
441BA071 KN
5
441BA072 KN
4
441BA026 KN
6