Stihl BT 360, Инструкция по эксплуатации

Страница: 18 / 28

BT 360
English
16
General Information
This setting provides an optimum fuel-air
mixture under most operating
conditions.
Readjust idle
Engine stops while idling
N
Turn the idle speed screw (LA)
clockwise until the drilling spindle
begins to rotate – then back it off 1/2
a turn.
Drilling spindle rotates when engine is
idling
N
Turn the idle speed screw (LA)
counterclockwise until the drilling
spindle stops rotating – then turn it
another 1/2 turn in the same
direction.
N
If the engine is down on power,
difficult to start or runs poorly at idle
speed, first check the spark plug.
N
Fit a new spark plug after about 100
operating hours – or sooner if the
electrodes are badly eroded. Install
only suppressed spark plugs of the
type approved by STIHL – see
"Specifications".
Removing the Spark Plug
N
Move the stop switch on the
powerhead to STOP.
N
Move the stop switch on the
handlebar to 0.
N
Pull boot off the spark plug.
N
Unscrew the spark plug.
Checking the spark plug
N
Clean dirty spark plug.
N
Check electrode gap (A) and
readjust if necessary – see
"Specifications".
N
Rectify the problems which have
caused fouling of the spark plug.
Possible causes are:
–
Too much oil in fuel mix.
–
Dirty air filter.
–
Unfavorable running conditions.
WARNING
If the spark plug comes with a
detachable adapter nut (1), screw the
adapter onto the thread and tighten it
down firmly to reduce the risk of arcing
and fire.
Adjusting the Carburetor
441BA027 KN
L A
STOP
Spark Plug
000BA039 KN
A
1
000BA045 KN